MeshWorks for Rhino is a plug-in for Rhino. It adds a salmagundi of meshing manipulation commands to Rhino. Some of the useful commands are given below: Hollow: This command hollows the meshing to a given wall thickness. Hollowing is particularly useful while preparing a example for Rapid Prototyping as it saves material, time and money while building a prototype. Offset: This command offsets a meshing to either shrink or extend it. PointsToMesh: This command creates a meshing from a pose of points. Stitch: This command knits loosely tied faces of a meshing and attempts to micturate a meshing water-tight. FillHoles: This command adds faces to an existing meshing in grade to fulfil any holes. The result is a water-tight meshing. ExtractSolid: This command extracts a worthy from a meshing. ExtractPlanarSurfaces: This command extracts a planar trimmed NURBS surface from a meshing. ExtractShells: This command extracts connected surfaces from a single meshing and creates a unexampled meshing for each connected surface. This is useful while working on different parts of a meshing. ExtractSurfaces: This command extracts surfaces of a meshing and creates a unexampled meshing for each surface. ExtractFeatures: This command extracts features of a meshing. This is useful to create a NURBS example from a polygon meshing. ExtractBoundaries: This command extracts the boundaries of an undetermined meshing. SplitMesh: This command splits a meshing with a planar surface into two parts. Smoothen: This command relaxes a meshing by removing sharp edges. Decimate: This command reduces the bit of faces of a meshing while maintaining continuity in the topology. MeshWorks for Rhino adds a unexampled menu to the existing Rhino menu containing all the added commands. Simply use this menu to fudge meshes.